LABEC J-MPB2 User Manual
Page 6
Installation
●
When installing products be sure to observe Installation Precautions
described in this manual.
●
To avoid electrical shock, connect the protective ground terminal to electrical
ground (safety ground).
●
When applying power to the products from a switchboard, be sure work is
performed by a qualified and licensed electrician or is conducted under the
direction of such a person.
●
Be sure to use the AC power cable provided.
Relocation
●
Turn off the power switch and then disconnect all cables when relocating the
product.
●
Use two or more persons when relocating the product which weights more
than 20 kg. The weight of the products can be found on the rear panel of the
product and/or in this Instruction Manual.
●
Use extra precautions such as using more people when relocating into or out
of present locations including inclines or steps. Also handle carefully when
relocating tall products as they can fall over easily.
●
Be sure the Instruction Manual be included when the product is relocate
Maintenance
●
To avoid electrical shock, be absolutely sure to unplug the AC power cable or
stop applying power before performing maintenance or checking.
●
Do not remove the cover when performing maintenance or checking. If the
cover must be removed, contact your LABORATORY EQUIPMENT PTY LTD
agent in advance.
●
To maintain performance and safe operation of the product, it is recommended
that periodic maintenance, checking, cleaning, and calibration be performed.
SERVICE
●
Internal service is to be done by LABORATORY EQUIPMENT PTY LTD
service engineers.
●
If the product must be adjusted or repaired, contact your LABORATORY
EQUIPMENT PTY LTD agent.