LABEC J-MPB2 - Manual (Page 17)

5.4 How to set the shaker parameters.
● Set the shaking speed(R.P.M) of shaker by turning "Shaking speed (R.P.M.) control dial
knob" and the shaking speed(R.P.M) will be displayed on the "R.P.M. meter".
5.5 How to start operation.
1 Connect the power plug to the power outlet.
2 Turn ON the Main Power Switch
3 Turn ON the POWER ON / OFF Key located on the temperature controller
4 Put the sample in the bath
5 Set and configure the settings by using temperature controller and shaker controller.
6 Press RUN/STOP Key once to start the operation.
(Press RUN/STOP Key once more to stop the operation.)
7 After the operation is completed, turn OFF the POWER ON / OFF Key, then turn OFF the
Main Power Switch.
8 Open the lid and take out the sample from the bath.
9 Disconnect the power plug from power outlet.
6. Maintenance and Service.
6.1 In case of cleaning inside of the equipment.
● Disconnect the power plug from power outlet.
● Clean the inside part of the bath with sponge or soft clothes getting wet by neutral
cleaner.
● Clean the inside part of the bath again with sponge or soft clothes getting wet by water.
● Clean with dry clothes.
● Do not use organic solvent.
● Do not use flammable or volatile chemicals such as benzene or alcohol to clean.
6.2 In case of cleaning exterior of the equipment.
● Disconnect the power plug from power outlet.
● Clean the exterior of the equipment with sponge or soft clothes getting wet by neutral
cleaner.
● Clean with dry clothes.
● Do not use organic solvent.
● Do not use flammable or volatile chemicals such as benzene, alcohol to clean.
● Do not use flammable or volatile chemicals such as benzene, alcohol to clean the
equipment.
● This equipment is not designed nor manufactured Explosion-proof, so never
place highly flammable material or explosive material inside the chamber, which
may cause an explosion or a fire.