KGUARD Security SHA28 - Manual (Page 67)

ENGLISH
Chapter 5: KGuard Web Client
DVR User’s Manual
67
4
After all settings are complete, click Apply at the bottom of the screen.
« TIP »
• To revert to default settings, click Default at the bottom of the screen.
• To cancel any modifications and retain the existing settings, click Refresh at the bottom of the screen.
5.5.4 Setting the Email Notification
Use the Email Setup menu to configure the sending and receiving email servers to use to send and receive email alarm
notifications.
1
On the Main Menu, click Remote Setting.
2
On the left panel, click Network > Email Setup.
3
Modify the necessary settings.
Menu item Description
Email Enable/Disable email configuration.
Interval Select the interval time between sending of emails (1/3/5/10 Minute).
SSL SSL (Secure Sockets Layer) protocol is used to secure your email account. Enable SSL if
the email server needs the SSL verification. Check with your email service provider for
the applicable setting.
SMTP
Server
Enter the SMTP server of the email server that you want to use to send emails.
SMTP Port Enter the SMTP port of the email server that you want to use to send emails.
Note:
By default, the SMTP port is 25 for email without SSL verification. For Gmail server
or for email that needs SSL verification, the SMTP port is 465, by default. Check with
your email service provider for the correct setting.
Sender Enter the email address from where you want to send the email.
Password Enter the sender’s email password.
Receiver Enter the email address where you want to send the email alarm notification.
4
After all settings are complete, click Apply at the bottom of the screen.
« TIP »
• To revert to default settings, click Default at the bottom of the screen.
• To cancel any modifications and retain the existing settings, click Refresh at the bottom of the screen.