KERN & SOHN KDE-T - Manual (Page 15)

15 KDE-T-BA_IA-e-1210
7.5 Weighing with tare

Deposit weighing vessel. After successful standstill control press the
button. The zero display appears. The weight of the container is now internally
saved.

Weigh the material, the net weight will be indicated.

After removing the weighing container, the weight of the weighing container
appears as negative display.

The tare procedure can be repeated as many times as necessary, for example
with initial weighing of several components for a mix (add-on weighing). The limit
is reached when the total weighing range capacity is full.

To delete the tare value, remove load from weighing plate and press .
7.6 Pre-Tare function
Setting the pre-tare function:
Using this function the weight of a tare vessel can be stored.
This value also remains saved if the balance meanwhile has been switched off and
switched on again.

Turn on weighing scale by and wait for zero to be displayed.

Put on empty vessel and press repeatedly until a flashing display of
“PrEtArE” appears.

Press . The current weight on the weighing pan will be saved as pre-tare
weight.

Weigh the material, the net weight will be indicated.