KERN & SOHN HFC 10T-3 - Manual (Page 30)

10. Press , the display for entering the lower limit value „SETLo“ appears.
11. Confirm by , the enabled digit flashes.
12. Use and to enter lower limit; see step 8.
13. Confirm input by , “SETLo“ will be displayed.
14. Press repeatedly to exit menu. From here evaluation takes place
whether the goods to be weighed are within the two tolerance limits.
Start tolerance check: Tare when using a weighing container.

Put on goods to be weighed, tolerance control is started. The signal lights indicate
whether the load is within the two set limits.
Depending on the setting in the menu an audio signal may be sounded.
Load below specified
tolerance Load within specified
tolerance Load exceeds specified
tolerance
The indicator [LO] will
appear The indicator [OK]
appears The indicator [HI] appears
• The tolerance control is not active when the weight is under 20d.
• To delete limits, enter “0000 kg“.
30 HFC-BA-e-1511