KERN & SOHN HFA 10T-3 - Manual (Page 33)


Press , “ULoAd“ will be displayed. Make sure that no
loads apart from the lifting tackle are attached to the hook.

Wait for stability display, then press .

Either use the displayed adjustment weight or change by
and , the currently enabled digit is flashing.
Press to select the digit to be amended.
To change the selected (flashing) digit, press
repeatedly until the desired value is displayed.
(example)

Confirm by , „LoAd“ will be shown.

Attach adjustment weight. Wait for stability display, then
press .

After successful adjustment „Pass“ will be displayed. After
that, the balance will carry out a self-test, followed by a brief
display of “Err4“.
Finally the balance returns automatically to weighing mode,
adjustment has been carried out successfully.
(example)
An adjusting error or incorrect adjusting weight will be indicated by the error
message; repeat adjustment procedure.
HFA-BA-e-1511 33