KERN & SOHN HFA 10T-3 - Manual (Page 29)

7. Acknowledge by .
8. Press again, the currently set upper limit value is displayed. The active digit
is flashing. Press to select the digit to be amended.
To change the selected (flashing) digit, press repeatedly until the desired
value is displayed.
9. Confirm entry by , “Ck Hi“ will appear.
10. Press , the display used to set the audio signal “bEEP“ will appear.
11. Press , the current setting for the acoustic signal will be shown.
12. Select desired setting (bp 1, bp 2, bp 3) by and confirm by .
13. Press repeatedly to exit menu. From here evaluation takes place whether
the goods to be weighed are within the two tolerance limits.
Start tolerance check:

Tare when using a weighing container.
Put on goods to be weighed, tolerance control is started. The signal lights indicate
whether the load is within the two set limits.
Load below specified
tolerance Load within specified
tolerance Load exceeds specified
tolerance
The indicator [LO] appears The indicator [OK]
appears
The indicator [HI] appears
• The tolerance control is not active when the weight is under 20d.
• To delete limits, enter “0000 kg“.
HFA-BA-e-1511 29