KERN & SOHN VFS 2T1 - Manual (Page 26)

VFS-BA-e-1111 26
7.5 Numerical tare input (PRETARE)
You may enter the tare weight at any time, that is, regardless whether the scales are in a
loaded or unloaded state. To achieve higher accuracy, a tare weight with a higher resolution
may be entered, regardless of the size of the weight and the display steps of the indicator.
A tare weight which is bigger than the maximum of the weighing system, will not be
accepted.
7.5.1 Enter tare weight
Call up the saved Pretare value:
Ö
Press , „PtL 0“ will be displayed
Ö
Select memory location (0-9) using , confirm memory location by ,
the pretare value stored on this memory location will be activated
Ö
Lift-off load, the gross weight is displayed, moreover „GROSS“ will appear
Ö
Use to switch over between gross and tare weight („NET“ is displayed).
Enter pretare value:
Ö
Press for 3 seconds, the tare value saved as last is displayed, the last digit
flashes.
Ö
To change the tare value saved as last:
Increase the flashing digit by , use to change over to the next decimal digit,
confirm by , „Pts 0“ is displayed
Ö
Select memory location (0-9) using , confirm memory location by , „0.0“ is
displayed
Ö
Lift-off load, the gross weight is displayed, in the display appears „GROSS“
Ö
Press , the net weight („NET“) is displayed
Ö
Use to switch over between gross and tare weight.