KERN & SOHN BBN 3T-3M - Manual (Page 3)

1 General
These installation instructions contain all data necessary for placing and
commissioning the weighing bridge KERN KFP 1500V40M.
2 Technical data
Model Weighing
range
Max Read-
ability
d Verificatio
n value
e Minimum
load
Min Cable
length
approx. Net weight
approx.
kg g g kg m kg
KFP 1500V40M 600 200 200 4 5 85
KFP 1500V40SM 1500 500 500 10 5 85
KFP 1500V40M 1500 500 500 10 5 150
KFP 3000V40M 3000 1000 1000 20 5 150
3 Basic instructions
3.1 Documentation
These installation instruction contain all data necessary for placing and
commissioning the weighing bridges KERN KFP V40.
In combination with a display unit, described below as weighing system, for operation
configuration, please refer to the operating instructions of the display unit.
3.2 Proper use
The balance you purchased is intended to determine the weighing value of material
to be weighed. It is intended to be used as a “non-automatic balance”, i.e. the
material to be weighed is manually and carefully placed in the centre of the weighing
plate.. As soon as a stable weighing value is reached the weighing value can be
read.
3.3 Improper Use
Do not leave permanent load on the weighing bridge. This may damage the
measuring system.
Impacts and overloading exceeding the stated maximum load (max) of the weighing
system, minus a possibly existing tare load, must be strictly avoided. The weighing
system could be damaged.
Never operate in an explosive environment. The serial version is not explosion
protected.
Changes to the weighing system's design are not permitted. This may lead to
incorrect weighing results, safety-related faults and destruction of the balance.
The weighing system unit may only be operated in accordance with the described
default settings. Other areas of use must be released by KERN in writing.
3 KFP V40-IA-e-1412