Keri Systems LAN-520 - Manual (Page 6)

LAN-520 AESP
Installation Guide
Page 6 of 13 P/N: 01519-001 Rev. B
14. Right-click the Device Installer application file and select Send to - Desktop (create shortcut).
4.2 Starting the Device Installer Program
NOTE: Contact your IT Administrator if the LAN-520 device is being installed on a different subnet than the host PC.
1. The Device Installer icon will be found on the desktop so double-click this to open up the application.
2. When you first open the program you may see a notification that no serial port has been detected, this is not of any
concern so select 'Do not prompt me about this'. Then click OK.
3. Click No to the prompt asking if you want to check for updates.
4. If the LAN-520 AESP module has been connected to a DHCP router which is on the same physical subnet as the host
PC then the device should appear. It should also show as online. The software automatically searches for the device
via its MAC address.
5. The device should display along with its assigned IP address. The MAC address will begin 00-80 if it is a LAN-520
AESP.