Keri Systems LAN-520 - Manual (Page 2)

LAN-520 AESP
Installation Guide
Page 2 of 13 P/N: 01519-001 Rev. B
2.0 Installing the LAN-520 AESP to a PXL-500
1. Power down the PXL-500 master controller.
2. On the master PXL-500 controller, remove jumpers from JP6 and JP7.
3. Insert the LAN-520 AESP into TB13 on the PXL-500. Orient the unit as shown in Figure 1.
NOTE: Mounting screws are supplied to secure the LAN-520 AESP to the PXL. The PXL will have to be removed from its
enclosure to do this.
4. Connect the RJ-45 port on the LAN-520 AESP to the network via a patch cable or directly to the host PC via a cross-
over cable.
5. Power up the PXL-500 (if this is a new PXL panel, a RAM reset is required).
Figure 2: Installing the LAN-520 AESP
LAN-520 AESP
Network
PXL-500
Master Controller
Lithium
Battery
JP6 JP7
NOTE: These jumpers
MUST be removed
or the LAN
connection will fail.