Click-to-link – Cardo G4 User Manual

Page 21

gli

Using the G4 with two Q2/Q2

pro

headsets:

Proceed with setup as in section 9.11a above and use either in Rider-

to-Passenger or in Bike-to-Bike mode.
Using the G4 and scala rider Q2/Q2

pro

with either a Solo, FM,

TeamSet

pro

or TeamSet (Driver) headset:

Q2/Q2

pro

: Proceed with setup as in section 9.11a above and use in

Bike-to-Bike mode.
Solo, FM, or TeamSet (Driver): Proceed with setup as in section

9.11b above but use only in Rider-to-Passenger mode.
Example:
To pair your G4 with a Q2 and an FM headset:

1. Pair your G4 with the Q2 as described in section 9.11a., using

CHANNEL “A”.

2. Pair your G4 with the FM as described in section 9.11b., using

CHANNEL “B” (For Rider-to-Passenger use only).

Using your G4 with another G4 and another scala rider model

(such as a Q2/Q2

pro

, Solo, FM, TeamSet

pro

or TeamSet [Driver])

1. Proceed with setup as in section 9.10b above for pairing the

second G4.

2. Proceed with setup as in section 9.11a or 9.11b above according

to the headset you want to use.

Example:
To pair your G4 with another G4 and a scala rider FM headset:

1. Pair your G4 with the second G4 as described in section 9.10a.,

using CHANNEL “A”.

2. Pair your G4 with the FM as described in section 9.11b., using

CHANNEL “B” [For Rider-to-Passenger use only].

Initiate Intercom calls from a G4

There are two ways to start an Intercom call with your paired headsets

while the G4 is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an Intercom

call will be established with both paired

devices, CHANNEL “A” and CHANNEL “B” (if

both are available).

CHANNEL BUTTON

CONNECT:
Single tap the CHANNEL

“A” or "B" Button to add or

remove the chosen channel

from an Intercom call.

10. CLICK-TO-LINK

Click-to-Link is the spontaneous “social” nature of your scala rider G4.

This unique feature will enable you to instantly initiate one-to-one

intercom calls with other G4 users in the near vicinity without going

through a pairing process in advance. Think of it as a private bike-to-

bike channel that you can set up on-the-fly with other scala rider G4

users that you spot next to a traffic light or along the road.
The Click-to-Link feature can of course be disabled at any time, blocking

any attempt by other G4 users to establish a spontaneous link.
USING CLICK-TO-LINK
Disable/Enable Click-to-Link: The feature can be turned on or off

via the Settings Customization Menu (see Section 4.2). By default,

this feature is DISABLED.
AUDIO SOURCES AND PRIORITIES
The different audio sources connected to the G4 are prioritized as

shown below, i.e. the higher priority source will always override and

interrupt the lower one.

scala rider