Basic tv and remote control operation, Press the power button to, Press the vol(ume) a/t – Philips PPC136C User Manual
Page 7: Press the ch(annel) a/ t, To load the supplied batteries, Remove the battery compartment lid on the, Place the batteries (two aa) in the remote. be, Reattach the battery compartment lid
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
B
asic
TV
and
R
emote
C
ontrol
O
peration
fBEGIN]
Press the POWER button to
I turn on the TV.
Press the VOL(ume) A/T
I buttons to adjust the sound level.
Press the CH(annel) A/ T
buttons to select TV channels.
Point the remote control
toward the remote sensor on
the TV when operating the TV
with the remote.
<$>.
Note: Always press two number
buttons on the remote when
selecting channels. For example:
press "0," then "6," for channel 6.
6 CH WXYZ
12:00 PM
, o Veee7
cdc
25
Note: The TVOLUMEA buttons can
be used as an AV SWITCH source
control to quickly select the FRONT
Auxiliary Input jacks on the TV for
operation.
(The TVOLUMEA buttons can also
be pressed simultaneously to switch
the set between Auxiliary and Antenna
input modes or, in Commercial mode,
to display the Features
menu.)
To load the supplied batteries
into the remote:
1. Remove the battery
compartment lid on the
back of the remote.
2. Place the batteries (two
AA) in the remote. Be
sure the (+) and (-) ends
of the batteries line up
as marked inside the case.
3. Reattach the battery
compartment lid.
S
mart
H
elp
Remember, the tuned
g channel number will appear
when you change the channel. You
also may press the STATUS button
on the remote control to see the
current channel number.