Clipcomm CWP-100 User Manual

Page 14

④

The changed parameter will apply only after the system restarts. Select “5:Restart” from the menu
and press ENTER button. Then the system will automatically restart with the new network
parameters.

6.2.3. Dynamic IP (DHCP) Setting

①

Follow the steps as MENU “3: System Setting” ”1: Network Setting” “3: DHCP”.

Use DHCP?

Yes No

②

Select “Yes” and press ENTER button. Then the system will automatically restart with the DHCP

mode.

6.2.4. ADSL Setting

①

Follow the steps as MENU “3: System Setting” ”1: Network Setting” “4: ADSL”.

②

You will see the figure as below once you select “4: ADSL”.

1: ADSL ID
2: ADSL Password

Connect ADSL

③

Select “1: ADSL ID” and input the ADSL ID.

Enter ADSL ID

myid_
MODE :

④

In the same way, input the ADSL password.

⑤

Select “3: Connect ADSL” and press ENTER button. Then the CWP-100 will automatically attempt
the ADSL connection.

⑥

In case ADSL connection fails, follow the steps as MENU “5: System Restart” to reattempt the
connection.