Intex CS7111 Krystal Clear Saltwater System 2013 - Manual (Page 19)

(189PO) MODEL CS7111 SALTWATER SYSTEM & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 07/31/2012
133
SAVE THESE INSTRUCTIONS
Page 19
English
OPERATING
INSTRUCTIONS
FILTER PUMP OPERATION
1. Make sure the unit is switched off. The switch is located on the control station.
2. Connect the power cord to a GFCI protected electrical outlet.
3. Turn both plunger valve handles fully counter-clockwise until they stop. This
opens the valve, allowing water to flow into the filter pump.
4. With water flowing into unit, the water pressure will allow the air trapped inside
to escape from the air release valves (1 & 7). When all the air has escaped
water will flow out of the valves (1 & 7). When this occurs gently finger tighten
the valves in a clockwise direction.
NOTE: The plunger valve is equipped with a vacuum release valve that will
automatically activate to minimize the suction at the pool outlet if the outlet is
blocked. This is an additional safety feature to prevent suction entrapment.
The vacuum release valve will reset once the blockage is removed and the
pump is switched off. To restart the system the air must be removed from the
filter pump per previous step.
5. Turn on the switch. The filter pump is now filtering the water.
6. The green "Pump" light on the control panel will light up, that indicates the filter
pump is running.
To prevent air lock, open the lower plunger valve (connected inlet hose)
first and then the upper plunger valve (connected outlet hose). Open air
release valves, lift and lower the inlet hose until water starts to flow out of
the air release valves, close air release valves.
IMPORTANT
Risk of electric shock. Connect this product only to a grounding type
receptacle protected by a ground-fault circuit interrupter (GFCI). Contact a
qualified electrician if you cannot verify that the receptacle is protected by
a GFCI.
WARNING
7
1