Canon LV-7575 - Manual (Page 40)

40
SETTING
Ceiling
Rear
Ceiling
When this function is “On,” the picture is top/bottom and left/right
reversed. This function is used to project the image from a ceiling-
mounted projector.
Rear
When this function is “On,” the picture is left/right reversed. This
function is used to project the image to a rear projection screen.
Power management
Time left until lamp off
Press the OK button at Power
management and this box appears.
Choose one of three settings with
the POINT LEFT/RIGHT buttons,
and go to the timer with the POINT
DOWN button and set time with
the POINT LEFT/RIGHT buttons.
For reducing power consumption as well as maintaining the lamp
life, the Power management function turns off the projection lamp
when the projector is not used for a certain period.
If the input signal is interrupted and no button is pressed for more
than 30 seconds, the timer display with “No signal” appears on the
screen to start the countdown. The countdown time can be set
between 1 and 30 minutes.
Select one of the following operations:
Ready . . . . . When the lamp has been fully cooled down, the
READY indicator starts blinking. In this condition,
the projection lamp is turned on if the input signal is
reconnected or any button on the top control or
remote control unit is pressed.
Shutdown . . When the lamp has been fully cooled down, the
power is turned off.
Off . . . . . . . The Power management function is off.
Simple menu
When this function is “On,” the value adjustment bar in the picture
IMAGE ADJUSTMENT Menu is displayed on the bottom left of the
screen.
Anamorphic
When this function is “On,” the screen image is forcibly changed
to the 4:3 image, even if the input signal is HDTV.
Menu position
This function is used to adjust the On-Screen Menu display
position. When the OK button is pressed, the adjustment screen is
displayed (arrows appear). Use the POINT UP/DOWN/ LEFT/RIGHT
button(s) to adjust the position. After making the adjustment, press
the OK button to return to the Menu screen.
Power management