Canon LV-7575 - Manual (Page 26)

26
COMPUTER INPUT
PC ADJUSTMENT
AUTO PC ADJUSTMENT
Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots, Horizontal and Vertical
positions to conform to your computer. Auto PC Adjustment function can be operated as follows.
Press the MENU button to display the On-Screen
Menu. Press the POINT LEFT/RIGHT buttons to move
the red frame pointer to the PC ADJUST Menu icon. 1
2 Press the POINT UP/DOWN buttons to move the red
frame pointer to the AUTO PC adj. icon and then press
the OK button.
This Auto PC Adjustment can be also executed by
pressing the AUTO PC ADJ. button on the top control
or on the remote control unit.
PC ADJUST MENU
Auto PC adj.
To store the adjusted parameters.
The system parameters from Auto PC Adjustment can be
memorized in this projector. Once the parameters are stored, the
setting can be done just by selecting Mode in PC SYSTEM Menu
(p.25). See MANUAL PC ADJUSTMENT on pages 27–28.
NOTE:
• Fine sync, Total dots, and Picture Positions of some computers can not be fully
adjusted with the Auto PC Adjustment function. When the image is not provided
properly with this function, manual adjustments are required. (See pages 27–28.)
• Auto PC Adjustment function cannot be operated in Digital Signal Input on the DVI
terminal and “480p,” “575p,” “480i,” “575i,” “720p (HDTV),” “1035i (HDTV),” or
“1080i (HDTV)” is selected on the PC SYSTEM Menu.
PC ADJUST Menu icon
Move the red frame pointer to the Auto PC
adj. icon and press the OK button.