Canon LV-7575 - Manual (Page 56)

56
APPENDIX
NOTE: Specifications are subject to change without notice.
ON-SCREEN
DISPLAY
RESOLUTION
H-Freq.
(kHz)
V-Freq.
(Hz)
D-VGA 640 x 480 31.47 59.94
D-480p 720 x 480
(Progressive)
31.47 59.88
D-575p 768 x 575
(Progressive)
31.25 50.00
D-SVGA 800 x 600 37.879 60.32
D-XGA 1024 x 768 43.363 60.00
ON-SCREEN
DISPLAY
RESOLUTION
H-Freq.
(kHz)
V-Freq.
(Hz)
D-WXGA1 1366 x 768 48.36 60.00
D-WXGA5 1368 x 768 46.50 50.00
D-1035i 1920 x 1035
(Interlace)
33.75 60.00
D-1080i 1920 x 1080
(Interlace)
33.75 60.00
D-1080i 1920 x 1080
(Interlace)
28.125 50.00 D-WXGA2 1360 x 768 47.70 60.00
D-WXGA3 1376 x 768 48.36 60.00
D-720p 1280 x 720
(Progressive)
37.50 50.00
D-720p 1280 x 720
(Progressive)
45.00 60.00
D-SXGA1 1280 x 1024 63.98 60.02
D-SXGA2 1280 x 1024 60.276 58.069
When a input signal is digital from DVI terminal, refer to the chart below.
D-1080psf/30 1920 x 1080 33.75 60.00
D-1080psf/25
1920 x 1080
28.125 50.00
D-1080psf/24
1920 x 1080
27.00 48.00
D-SXGA+ 1 1400 x 1050 63.97 60.19
INDICATORS AND PROJECTOR CONDITION
Check the indicators for projector condition.
✳
Depending on the condition of signals and the type and length of cables, these signals may not be properly viewed.
✳
✳
✳
• • • on • • • dim • • • off • • • blinking
The projector is OFF. (The AC power cord is unplugged.)
The projector is ready to be turned on with the POWER
button.
The Warning Temp. indicator blinks red to let you know the
internal temperature of the projector exceeds a normal level.
If the temperature goes up further, the projector will be
turned off automatically and the Ready indicator goes out.
When the projector is cooled down enough and the
temperature returns to normal, the READY indicator lights
green and the projector can be turned on again. (The
WARNING TEMP. indicator keeps blinking.) Check and clean
the air filters.
Projector Condition
The projector is operating normally.
The projector is cooled down enough and the temperature
returns to normal. When turning on the projector, the
WARNING TEMP. indicator stops blinking. Check and clean
the air filters.
LAMP
REPLACE
orange
Indicators
READY
green
LAMP
red
WARNING
TEMP.
red
✽
✽
✽
✽