Philips FW-C100 - Manual (Page 27)

o RECORDING CLOCK
Dubbing tapes (from tape deck 2
to tape deck 1)
1 Load the prerecorded tape into tape
deck 2 and a blank tape into tape
deck 1.
• Make sure both tapes have their full
spool to the left.
2 Press PAUSE on tape deck 1.
3 Press RECORD on tape deck 1.
The REC starts flashing.
4 Press PLAY ► on tape deck 2.
• Recording \will start automatically.
5 Press STOP'OPEN on tape deck 1
and tape deck 2 to stop dubbing.
Notes:
- At the end of side A, fip the tapes to
side B and repeat the procedure.
- Dubbing of tapes is only possible from
tape deck 2 to tape deck 1.
- To ensure good dubbing use tapes of
the same length.
Recording from other
sources
(only on tape deck 1)
1 Load a blank tape into tape deck 1.
2 Press CD, TUNER or AUX.
• Start playback of the selected source.
3 Press RECORD on tape deck 1 to
start recording.
The REC starts flashing.
4 Press PAUSE to interrupt
recording.
5 Press STOP*OPEN on tape deck 1
to stop recording.
Note:
- During recording, it is not possible to
listen to another sound source.
View Ciock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD,TUNER,
etc.). The clock will be displayed for
about seven seconds.
• Press CLOCK*TIMER briefly (on
the system only).
PM o r : 3 8 ” (the
current time) will be displayed
depending on whether you have
selected 12- or 24-hour mode.
^iii be displayed if the
clock is not set.
Clock Setting
The clock can be set in either 12- or
24-hour mode, e.g. " !B-Gu am ” or
‘ uu-uu“. Before setting the clock you
must be in the View Clock mode.
1 Press CLOCK*TIMER to select
clock mode.
2 Press PROGRAM to select 12- and
24- hour mode.
-* If 12-hour mode is selected,
” IB-80“ starts flashing and the
AM lights up.
“*• If 24-hour mode is selected,
"00-uu'’starts flashing.
3 Set the hour with "44 or ►► on the
system.
4 Set the minute with N or Hon the
system.
pg 01-28/C100/37-EnN 12/6/00, 2:07 PM 3139 115 20881 (ENG)