Philips FW-C100 - Manual (Page 15)

e PREPARATION
(A) AM Loop Antenna
Connection
Connect the supplied loop antenna to
the AM ANTENNA terminal. Place the
AM loop antenna far away from the
system and adjust its position for the
best reception.
( b ) FM Wire Antenna
Connection
Connect the supplied FM wire antenna
to the FM AERIAL (FM ANTENNA)
300 Q terminal. Adjust the position of
the FM antenna for the best reception.
Outdoor Antenna
For better FM stereo reception,
connect an outdoor FM antenna to the
FM AERIAL (FM ANTENNA) 300 Q
terminal using a 300 £2 dipole wire.
FM AERIAL 3000 FM ANTENNA 3000
(c) Speakers Connection
• Connect the right speaker to Front
terminal Ft, with the colored wire to
+ and the black wire to —.
• Connect the left speaker to Front
terminal L with the colored wire to
+ and the black wire to —.
• Clip the stripped portion of the
speaker wire as shown.
(D) Connecting other
equipment to your
system
You can connect the audio left and right
OUT terminals of a TV,VCR Laser Disc
player DVD player or CD Recorder to
the AUX IN terminals at the rear of the
system.
(D AC Power Supply
After all other connections have been
made, connect the AC power cord to
the system and to the wall outlet.
CAUTION:
- For optimal sound performance, it is
recommended to use the supplied
speakers.
- Do not connect more than one speaker
to any one pair of +/— speaker
terminal.
- Do not connect speakers with
impedance lower than the speakers
supplied. Please refer to
SPECIFICATION section of this manual.
Inserting batteries into the
Remote Control
• Insert the batteries (not supplied)
into the remote control as shown in
the battery compartment (Type R06
orAA).
CAUTION
- Remove batteries if they are
exhausted or not to be used for a
long time.
- Do not use old and new or
different types of batteries in
combination.
- Batteries contain chemical
substances, so they should be
disposed off properly.
pg 01-28/C100/37-EnN 12/6/00, 2:07 PWl 3139 115 20881 (ENG)