Philips FW-C100 - Manual (Page 23)

« TUNER
Note:
- For 'PLUG & PLAY' feature, please refer
to page 12.
Tuning to radio stations
1 Press TUNER (FM*AM) to select
TUNER mode.
-*• "TU m 'EP" w ¡I1 be displayed.
A few seconds later; the current
radio frequency will be displayed.
2 Press TUNER (FM*AM) again to
select the desired waveband : FM or
AM.
3 Press or ►► for more than one
second, then release.
The display will show'SERPCH”
until a radio station with sufficient
signal strength is found.
• Repeat this procedure until the
desired station is reached.
• To tune to a weak station, briefly
press -4^ or ►► repeatedly until the
display shows the desired frequency
and/or when the best reception has
been obtained.
Storing Preset Stations
You can store up to 40 radio stations in
the memory. When a preset radio
station is selected, the preset number
appears next to the frequency on the
display.
Automatic programming
1 Press TUNER (FM*AM).
2 Press PROGRAM for more than
one second.
-*■ The PROG flag starts flashing and
‘‘FluT[j”will be displayed.
The system will search for every
available station in the FM
waveband first, then search the
AM waveband.
All available stations will be stored
automatically.The frequency and
preset number will be displayed
briefly.
The system will stop searching
when all the available radio
stations are stored or when the
memory for 40 preset radio
stations is used.
-*■ The system will remain tuned to
the last stored preset radio
station.
Notes:
- You can cancel the automatic
programming by pressing PROGRA/Vl or
■ (on the system only).
- If you want to reserve a section of
preset numbers, for example preset
numbers 1 to 9, select preset 10
before starting automatic programming
only the preset numbers 10 to 40 will
be programmed.
Manual programming
1 Press TUNER (FM*AM).
2 Press TUNER (FM*AM) again to
select the desired waveband : FM or
AM.
3 Press PROGRAM for less than one
second.
-* The PROG flag starts flashing.
-* The next available preset number
will be displayed for selection.
4 Press 44 or ►► to tune to the
desired frequency.
• If you wish to store the radio station
to another preset number press T
or ▲ to select the desired preset
number
5 Press PROGRAM again.
-*• The PROG flag disappears and
the radio station will be stored.
• Repeat steps 3 - 5 to store other
preset radio stations.
Notes:
- When 40 radio stations are stored and
you attempt to store another radio
station, the display will show "FULL ”. If
you want to change an existing preset
number, repeat steps 3 - 5 .
- You can cancel manual programming
by pressing ■ (on the system only).
- During programming if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
Tuning to Preset Radio
Stations
• Press ▼ or A to select the desired
preset number.
-* The preset number radio
frequency and waveband appear
on the display.
pg 01-28/C100/37-EnN 12/6/00, 2:07 PM 3139 115 20881 (ENG)