Philips MAS-300 - Manual (Page 9)

General Information
Thlt system compiles with the FCC rules,
Part IS and with 21 CFR 1040.10.
Operation Is subject to the following two
conditions:
- This device may not cause harmful
Interference, and
- This device must accept any Interference
received. Including Interference that may
cause undesIred operation.
Supplied accessories
- 2 speaker boxes
- remote control
- AM loop antenna
- FM wire antenna
Environmental information
All unnecessary packaging has been omitted. We
have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which can be
recycled and reused if disassembled by a
specialized company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old
equipment
Safety information
Before operating the system, check that the
operating voltage indicated on the typeplate (or
the voltage indication beside the voltage
selector) of your system is identical with the
voltage of your local power supply. If not please
consult your dealer
Place the system on a flat hard and stable
surface.
Place the system in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
Do not expose the system, batteries or discs to
excessive moisture, rain, sand or heat sources
caused by heating equipment or direct sunlight
The lens may cloud over when the system is
suddenly moved from cold to warm
surroundings, making it impossible to play a disc.
Leave the system in the warm environment until
the moisture evaporates.
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
When the system is switched to Standby
mode, it is stili consuming some power.
1b disconnect the system from the
power suppiy compieteiy, remove the AC
power plug from the wail socket.