Philips MAS-300 - Manual (Page 24)

Clock/Timer
CQIIW^ ^njWK^
ao®
Q®S
CHDCeDCsD
r«l CED (3
IBSB
View clock
The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(CD or TUNER for example)
• Press CLOCK*TIMER
•* The clock is displayed for a few seconds.
^ If the clock has not been set, is
displayed.
Clock setting
The clock can be set in either 12-hour or
24-hour mode (" li^DD
am " or "00=00", for
example)
1
In standby or view clock mode, press
CLOCK'TIMER once. In other source mode,
press CLOCK'TIMER twice.
2
Press PROGRAM repeatedly to select clock
mode.
" (i=00 am " or TJO- OD" starts flashing.
3
Press
-44
or
►►
on the system repeatedly to set
the hour.
4
Press 14 or W on the system repeatedly to set
the minute.
5
Press CLOCK*TIMER again to store the
setting.
•4 The dock starts working.
To exit without storing the setting
• Press ■ on the system.
Notes:
- The dock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
- During clock setting, if no button is pressed
within 90 seconds, the system wili exit dock setting
mode automatkaliy.
Timer setting
The system can switch on to CD orTUNER
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT!
- Before setting the timer, ensure that the
dock Is set correctly.
- The timer will always be twitched on
after It has been set.
- The timer will not start If a recording Is in
progress.
- The volume will increase gradually from
the minimum level to the last tuned volume
Press and hold CLOCK*TIMER for more than
two seconds to select timer mode.
" l(?=QD
am " or "00=00" or the last timer
setting starts flashing.
^ © starts flashing
24