Philips MAS-300 - Manual (Page 25)

Clock/Timer
2
Press CD 1/2/3, TUNER or PROGRAM to
select the desired source.
"CD I [or 3, i3] “ It ■ I!" indicates the CD
mode is selected.
"I'D ¡;;;:;i" indicates theTuner mode is
selected.
"PRDG li I!: !i li" indicates the CD program
mode is selected.
• Before setting timer make sure the music source
has been prepared.
CO 1/2/3 - Load the disc(s).To start from a
specific track, make a program (refer to “CD
Operation - Programming the disc tracks"),
TUNER - tune to the desired radio station.
3
Press
«
or
►►
on the system repeatedly to set
the hour for the timer to start
4 Press M or W on the system repeatedly to set
the minute for the timer to start
5
Press CLOCK'TIMER to store the timer.
^ "TlfCR ON" is displayed, followed by the set
timer ““ " and the selected source.
® remains on the display.
• At the preset time, the selected sound source
will play.
To exit without storing the setting
• Press ■ on the system.
Notes:
- When the preset time is reached and the
selected disc tray is empty, the next ayailable disc
will be selected. If oil the disc trays are not
avaHable.Tuner will be selected automatically.
- During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
Deactivating the timer
Press and hold CLOCK’TIMER for more than
two seconds.
Press ■ on the system to cancel the timer,
-» "CONCEL" is displayed and the ® disappears.
Activating the timer (for the same preset
time and source)
1
Press and hold CLOCK*TIMER for more than
two seconds.
2
Press CLOCK'TIMER again to store.
The last set timer information is displayed for
a few seconds and ® is shown.
Sleep timer setting
The sleep timer enables the system to switch to
standby mode automatically at a preset time.
1
Press SLEEP on the remote control repeatedly
to select a preset time.
The selections are as follows (time in
minutes):
15 - 30 - N5 - BO - 30 - GO -
orr- S ...
•4 "SLEEP “ I!" or "OEE" is displayed, "a)!” is the
time in minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP button.
-♦zzz is shown, except for "OEE" mode.
The sleep timer is now set Before the system
switches to standby mode, a countdown of 10
seconds is displayed.
"SLEEP lO" - "SLEEP 3"....-"SLEEP I"
-"SLEEP"
To check the remaining length of time
after sleep timer is activated
• Press SLEEP once.
To change the preset sleep timer
• Press SLEEP again while the remaining sleep
timer is showa
The display will show the next sleep timer
options.
1b deactivate the sleep timer
• Press SLEEP repeatedly until "OEE" is displayed,
or press the STANDBY ON button.
2S