Philips MAS-300 - Manual (Page 14)

Basic Functions
Demonstration mode
The system has a demonstration mode that
shows the various available features.
To activate the demonstration
9 In standby mode, press and hold ■ on the
system until VCLCOtIC’ is displayed.
The demonstration will begin.
7b deactivate the demonstration
• Press and hold ■ on the system until
"BEflO Orf" is displayed.
The system will switch to standby mode.
Note:
- If you bays not deaoiyated the demonstration, it
will resume five seconds after the system switches
to standby mode.
Switching the system on
In standby/demonstration mode
• Press STANDBY ON to switch on the last
selected source.
• Press CD 1/2/3, TUNER or
TAPE (TAPE 1/2).
• Press CD OPEN/CLOSE.
^ The system will switch to CD mode.
Switching the system to standby
mode
In demonstration mode
• Press and hold ■ on the system.
In any other source mode
• Press STANDBY ON (or (¡) on the remote
control).
The clock will appear on the display when the
system is in standby mode.
Dim mode
You can select the desired brightness for the
display.
In any source mode (except standby mode),
press DIM repeatedly to select; DIM 1, DIM 2,
DIMS or DIM OFF.
^ DIM is shown, except for DIM OFF mode.
DIM
mod«
SHghtnMf
1 normal off
2 hair
on
3 half off
OFF normal on
Note:
- In standby mode, pressing DIM to select half or
full brightness fiir clock display.
Volume control
PressMASTERVOLUMEAorT (VOL +
or — on the remote control) to increase or
decrease the volume level.
To listen through the headphones
Connect the headphones plug to
the jpj socket at the front of the
system.
•* The speakers will be muted.
To switch off the volume temporarily
Press MUTE on the remote control.
Playback will continue without sound and
"MUfE* is displayed.
To restore the volume, press MUTE again or
increase the volume level.
14