Philips CDC 925/20S - Manual (Page 10)

SYSTEM ASPECTS ADDITIONAL INFORMATION
MAINTENANCE
m
3 I
(0_ !
S’
I
/f you record a programme:
- Synchronized recording will stop after the last track.
If you record a CD:
- If, after the last track of the CD, there is still enough space
available on side B, then the deck will go into PAUSE mode.
- The turntable will rotate to the next CD so that some more
tracks can be recorded from this CD (this will also happen if
the last track has been recorded on side A).
- As soon as playback of the new CD starts, the deck
continues recording.
• Press STOP/CP if this is not required
NOTE!
- As soon as you start recording, the other changer
functions (except TIME and REVIEW) will temporarily be
switched off to prevent the recording being interfered
with; Err lights up if you press one of the other buttons
during play/recording.
- You can stop playback/recording by pressing STOP/CP.
- The CD DUBBING function will be cancelled if the CD
changer (or the system) is set to STAND BY mode
AUTOMATIC SOURCE SELECTION
AUTOMATIC STOP
If the AUTO SELECT button on the amplifier is pressed, the
CD changer will automatically be activated as soon as you
press QUICK PLAY or PLAY/REPLAY.
If the AUTO SELECT button on the amplifier is pressed, the
CD changer will automatically go into the PAUSE mode as
soon as another source in the system is selected (except
when CD DUBBING is active).
The CDs
• Never write on the printed side of a CD.
• Do not attach any stickers to the CD.
• Keep the shiny surface of the disc clean. Use a soft lint-free
cloth and always wipe the disc in a straight line from centre
to edge.
• Never use cleaning agents for conventional records.
• Detergents or abrasive cleaning agents should not be used
either.
The changer
• A chamois leather slightly moistened with water is sufficient
for cleaning the changer.
• Do not use cleaning agents containing alcohol, spirits,
ammonia or abrasives.
FAULTS AND THEIR LIKELY CAUSES
If a fault occurs, run through the points listed below before
taking your changer for repair. Check whether:
- condensation has formed on the lens of the laser due to a
dramatic change in temperature; this will disappear
automatically after some time;
- the CDs have been inserted correctly with the printed side
up and that there are CDs in the compartment;
- the (current) CD is dirty, badly scratched or warped;
- the changer has been connected to the PHOI
n IO socket of
the amplifier.
If the fault remains, try to clear it by switching the changer off
and on again.
If this also fails to help, consult your dealer.
Under no circumstances should you repair the changer
yourself as this will invalidate the guarantee!
STAND BY
• With the STAND BY button on the remote control of the
system you can set the changer to STAND BY mode.
The changer will go to STAND BY mode automatically if the
whole system is set to STAND BY mode.
- If the CD compartment was open, it will now close.
- Any programme present will be erased.
• Press any of the following buttons to cancel the STAND BY
mode:
DISC SELECT (1-5), PLAY/REPLAY, STOP/CP, SCAN,
SHUFFLE, 0-9, EDIT, OPEN/CLOSE, !◄ TRACK ►! or
P(rogramme).
TIMER
• Using the TIMER function you can have playback of a CD
(this is always the CD with the lowest number) started at a
particular time; for this refer to the operating instructions of
the tuner (e.g FT930).
- Err will light up if there is no CD in the CD compartment at
the moment playback is supposed to start or if you press
any button during playback in the TIMER mode.
10