Troubleshooting – Philips CDC771V User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLESHOOTING
If a fault occurs run through the points listed below before taking your changer for repair.
If the fault remains, try to clear it by
switching the changer off and on again.
If this also fails to help, consult your dealer.
Under no circumstances shouid you repair the changer yourself as this will invalidate the guarantee!
s:
.¡2
O)
c
UJ
SYMPTOM
POSSIBLE CAUSE
REMEDY
- Playback does not start or interrup
tion of playback.
-
The current CD has been loaded
upside down.
-
No CDs inserted.
-
The current CD is badly scratched
or dirty.
-
Moisture condensation on the lens.
•
Reload the CD, label side up.
•
Insert the CDs, label side up.
•
Clean the CD with a soft, lint-free
cloth.
•
Leave the CD changer in a
warm environment until the
moisture evaporates.
- Sound skips (at the same part).
- The current CD is dirty.
• Clean the CD with a soft, lint-free
cloth.
- The current CD skips tracks.
- The CD is damaged or dirty.
• Replace or clean the CD.
- Playback does not start from the
first track (of the current CD).
- PRG (program) or SHUFFLE acti
vated.
• Switch off SHUFFLE or clear
programme.
- No sound or bad sound.
-
Loose or wrong connections.
-
Strong magnetic fields near the CD
changer.
•
Check connections.
•
Find another place for the unit or
change connections.
- No sound or bad sound on head
phones.
-
Level control set to - position.
-
Headphones plug is dirty.
•
Set level control.
•
Clean plug.
- Remote control does not function.
- Batteries are empty.
• Replace the batteries.
- Remote control commands are not
properly received.
- The distance between remote control
and Video CD player is larger than
10
meters.
•
Use remote control receiver EM
2200
/
2201
.
•
Reduce the distance between
the remote control and Video CD
player.
- No picture on the monitor.
-
The cable is not connected to the
monitor terminal.
-
The monitor is powered off.
-
The undefined CD DISC is used.
•
Connect the cable between CD
player & monitor.
•
Switch on the monitor power.
•
Use the defined DISC (Video,
CD. CD-I Digital Video. CD-G)
17