Philips SIC 4523 - Manual (Page 6)

Or you could charge the battery by AC adaptor (optional
accessory) to a power outlet.
®l
Battery power status
^77i\ f77I\ f~7i'
Full
3/4
Half Empty
CAUTION
* It takes approximately 4 hours to fully charge a depleted battery.
* The camera can be charge at ambient temperatures between 0°C
(32°F) and+40°C (104°F).
* The battery does not need to be fully discharge or exhausted before
being recharged.
* Lithium-ion battery loses their charge even when not used. So, be sure
to charge the battery before taking pictures.
* To ensure that your battery lasts as long as possible, switch the
camera off when you are not using it.
* The number of available shots will be lower at low temperatures. You
can increase the amount of power produced by putting the camera in
your pocket or another warm place to heat it just before taking pictures.
If you are using a heating pad, take care not to place the camera
directly against the pad.
10
|Loadinq SD/MMC Card
Insert SOI MMC card into memory card slot and push it all
the way in.
When the optional SD card is installed:
* All images by default will be automatically stored in
SD/MMC card
* With SD/MMC card installed, the images/ movies/ audio
clips in built-in memory cannot be played back. To
playback the images/ movies/ audio clips in built-in
memory, remove SD/MMC card first.
* When you format camera, it would format the images/
movie/ audio clips on SD card only. To format the
images/ movies/ audio clips which on built-in memory,
remove SD card.
11