Philips FW-R55 - Manual (Page 6)

General information
Supplied accessories
- 2 loudspeakers including 2 speaker cables
- Remote control
- 2 batteries for the remote control, size AA
- AM (MW) loop antenna
- FM wire antenna
- Power cable
Setup information
Place the unit on a flat, hard and stable surface. Make sure
to leave at least 3.5 cm (1.5 inches) free around the unit to
prevent overheating. Active mobile phones near the unit
may cause malfunctions.
Maintenance
Clean the unit with a soft,
slightly dampened, lint-free cloth. Do
not use any cleaning agents as they
may have a corrosive effect.
Do not expose the unit, batteries or
discs to humidity rain, sand or
excessive heat (caused by heating
equipment or direct sunlight).
Disc handling
If the CDR Mini Hi-Fi system fails to read discs correctly, use
a commonly available cleaning-CD to clean the lenses before
submitting the unit to repair Other cleaning methods may
destroy the lenses. Always keep the trays closed to avoid dust
on the lenses.
The lenses may cloud over when the unit is suddenly moved
from cold to warm surroundings. Playing a disc is not possible
then. Leave the unit in a warm environment until the
moisture evaporates.
To take a disc out of its box easily,
press the center spindle while lifting
the CD(RW). Always pick up a
CD(RW) by the edge and put it
back in its box after use.
Never write on a CD or attach a
sticker to it Write only on the printed side of a CDR or
CDRW, and only with a soft felt-tipped pen.
To clean a disc, wipe it in a straight
line from the center toward the
edge using a soft, lint-free cloth. A
cleaning agent may damage the disc!
Environmental information
All redundant packing material has been omitted. We have
tried to make the packaging easy to separate into three
mono materials: cardboard (box), polystyrene foam (buffer)
and polyethylene (bags, protective foam sheet).
Your unit consists of materials which can be recycled if
disassembled by a specialized company. Please observe the
local regulations regarding the disposal of packing materials,
exhausted batteries and old equipment.
As an ENERGY STAR® partner
Philips has determined that this
product meets the ENERGY STAR®
guidelines for energy efficiency.
The set complies with the FCC-Rules, Part 15 and
with 21 CFR 1040.10. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.