To a tv and a vcr using rf cables – Philips STU909 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. To a Philips Wide-Screen TV set (e.g. 36ML8906)
and a Wide-Screen VCR (e.g. VR813)
In order to make automatic recording and display of D2-MAC Wide-Screen
(16:9) pictures possible, a special configuration is recommended as shown in
the drawing.
Note:
In the configuration menu, section 6, item 2 (Wide-Screen TV) needs to be
■YES'.
4. To a TV and a VCR using RF cables
O Connect the cable coming from your normal TV antenna (or cable-TV) to the
input marked CABLE of your STL) 909.
O Connect the ® output to your VCR antenna input using the RF cable
delivered with your STU 909.
O Connect the VCR output to your TV.
O Connect your STU 909 to the mains.
O Press the ON switch.
O Press MENU on your remote control.
O Now tune your TV and VCR to the signal from the STU 909 until you see this
picture. If necessary refer to the manual of your TV and VCR.
O Store the satellite signal under a programme number you do not have in use
yet on your TV and VCR.
If patterning on this or any other programme on your TV occurs, you must
slightly modify the position of the control marked on the back of your
STU 909, using a small screwdriver. Then tune again your TV and VCR.
O If you have any more connections to make, disconnect the STU 909 from the
mains.
1 PROGRAMME LIST
2 SATELLITE LIST
3 SOUND SELECTION
4 RECORD SELECTION
5 HEADPHONE
6 SPECIAL ITEMS
7 SUBTITLE SELECTION
8 PAY TV INFO
9 INSTALLATION
s«l«ctM *9. off