Philips STU909 - Manual (Page 4)

J
Introduction
We hope you will enjoy using your new Philips STU 909 multi-standard
satellite tuner. This tuner will open up an entire world of satellite TV reception;
both of the new D2-MAC broadcasts and all today’s conventional PAL
transmissions. In particular, the STU will allow you to receive the increasing
number of programmes broadcast in the new D2-MAC Wide-Screen 16:9
format.
You can use your Philips STU 909 satellite tuner with one or two fixed satellite
dish antennae, or with a motor-controlled rotatable dish which will allow you to
receive programmes from any satellite you wish, if your dish is suitable.
We advise that you ask your Philips dealer to handle the installation of your
Philips satellite dish antenna and your STU 909 tuner.
Safety instructions
To avoid short-circuits, which may cause fire or electric shock, do not expose
this Philips STU 909 receiver to rain or moisture.
Dangerous voltage inside. Do not open the cabinet. There are no user
serviceable parts inside. Repairs should be carried out by qualified service
personnel only.
NEVER connect or modify cables while the receiver is connected to the
mains. Ensure that no objects or fluids pass through the ventilation openings.
Do not put your receiver close to an external source of heat (radiator, etc.).
Ensure that air can circulate freely through the ventilation openings of the
receiver. Your receiver supplies 14 or 18 V DC voltage to your satellite dish
antenna. Make sure you only connect your satellite dish to the satellite dish
inputs, 27 and 28, and nothing else.
MAINS connection
Do not connect the receiver to the mains yet, but continue reading these
Operating Instructions!
NEVER connect or modify cables while the receiver is connected to the mains.
Positioning your Philips STU 909
Satellite Tuner
The STU 909 is intended for use in a domestic environment only and should
never be operated or stored in excessively hot or humid atmospheres.
Choose a position some distance away from radiators or other sources of
heat.
Leave a clear space of at least 3 cm all around the set for ventilation. Make
sure that curtains, cupboards, etc. cannot obstruct the air flow through the
ventilation openings.
Insert batteries in the remote control
O Remove the battery cover located on the back of the remote control handset.
O Insert three batteries (type R03S 1.5 V).
O Replace the battery cover.