2 direct code entry, Notes, 2 direct code entry 1 – Philips SRP1003WM/17 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2.2.2 Direct code entry
1
Turn on the device (TV, Cable box, Satellite
box, etc.) you wish to operate.
2
Press and hold the
(S™;) button until
the red light
indicator®
remains lit, then
release the55)
button.
Press and release
the desired mode
button ^v~), [
cbl
)
or^D)).
•
The red light
indicator®
flashes, then remains lit.
Enter the 4 digit code from the code tables
(on separate sheet).
With the device turned on, press several
buttons to test if the device responds.
•
Ifthe device responds properly, you
have successfully found a valid code for
your device.
Repeat steps
1
to
4
for other devices you
wish to set up the remote control for.
Write your codes down here for easy
reference later.
Device
Code
TV
CBL/SAT
DVD/DVR
Notes
After a valid code entry, the red light
indicator® turns off.
For an invalid code, the red light
indicator® flashes first, then turns off.
In this case you have to enter Setup
mode again and enter a new code.
Ifsome buttons do not operate your
equipment, try one ofthe other codes
for your brand.
EN
P1003WM_17__Manual_80_210.indd 9
25-11-09 13:1