Notes, 5 troubleshooting, Note – Philips SRP1003WM/17 User Manual
Page 17: Setup
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Select TV by
pressing the^y~)
II
mode button for ,
more than 1 second.
• The remote
control sends
out the ‘Select TV’ command.
Press and
immediately release
the^") button.
Then press and
immediately release
the^5 mode
button to select DVD.
• The remote control sends out the
‘Select DVD’ command.
Notes
This method can be applied similarly to
all combo devices (TV/DVR,TV/DVD,
etc.) and is available for all device modes.
Note that this feature is not supported
by all codes.
5 Troubleshooting
Note
This remote control operates the common
features of most but not all models and
brands of IR (Infrared) controlled Audio/
Video equipment.This remote control may
provide functions that are not available on
your equipment.
Setup
I cannot enter Setup mode.
Battery level too low or battery lifetime came to
an end.
• Replace the batteries. For this refer to
chapter 2.1.
After replacing the batteries, test ifthe
remote control still operates your devices.
If it does not, you have to set up the
remote control again. For this refer to
chapter 2.
EN
17
P1003WM_17__Manual_80_210.indd 17
25-11-09 13:1