Philips SRP1003WM/17 - Manual (Page 18)

Operation
The remote control does not wake up
anymore.
Battery level too low or battery lifetime came to
an end.
• Replace the batteries. For this refer to
chapter 2.1.
After replacing the batteries, test ifthe
remote control still operates your devices.
If it does not, you have to set up the
remote control again. For this refer to
chapter 2.
The device I want to operate does not
respond at all/does not respond to all of
the button commands.
• Check ifthe buttons you press are available
on the original remote control ofthe
device.
Wrong code selected during setup.
• Set up the remote control again for the
device.
Ifsome buttons do not operate your
equipment, try one ofthe other codes for
your brand. For this refer to chapter 2.2.2 .
It may be that the buttons that you are trying to
use have a different naming on the original remote
control.
• Try out all buttons to find the one(s) you
need.
Batteries
Will my settings be deleted when I
replace the batteries?
No. All user settings will be retained in the
remote control memory for 5 minutes.
Warning
(Installed) batteries shall not be exposed to
excessive heat such as sunshine, fire or the
like.
18 EN
P1003WM_17__Manual_80_210.indd 18 25-11-09 13:1