Cisco ONS 15454 SDH - Manual (Page 29)

15-29
Cisco ONS 15454 SDH Reference Manual, R4.6
April 2008
Chapter 15 Performance Monitoring
15.6.2 STM-1E Card Performance Monitoring Parameters
Table 15-31 High-Order VC4 and VC4-Xc Path PM Parameters for the Near-End
STM-1E Cards
Parameter Definition
HP-ES High-Order Path Errored Second (HP-ES) is a one-second period with one
or more errored blocks or at least one defect.
HP-ESR High-Order Path Errored Second Ratio (HP-ESR) is the ratio of errored
seconds to total seconds in available time during a fixed measurement
interval.
HP-SES High-Order Path Severely Errored Seconds (HP-SES) is a one-second
period containing 30 percent or more errored blocks or at least one defect.
SES is a subset of ES.
HP-SESR High-Order Path Severely Errored Second Ratio (HP-SESR) is the ratio
of SES to total seconds in available time during a fixed measurement
interval.
HP-BBE High-Order Path Background Block Error (HP-BBE) is an errored block
not occurring as part of an SES.
HP-BBER High-Order Path Background Block Error Ratio (HP-BBER) is the ratio
of BBE to total blocks in available time during a fixed measurement
interval. The count of total blocks excludes all blocks during SESs.
HP-UAS High-Order Path Unavailable Seconds (HP-UAS) is a count of the seconds
when the VC path was unavailable. A high-order path becomes
unavailable when ten consecutive seconds occur that qualify as HP-SESs,
and it continues to be unavailable until ten consecutive seconds occur that
do not qualify as HP-SESs.
HP-EB High-Order Path Errored Block (HP-EB) indicates that one or more bits
are in error within a block.
Table 15-32 Near-End Pointer Justification PM Parameters for STM-1E Cards
Parameter Definition
Note In CTC, the count fields for PPJC and NPJC PM parameters appear white and blank unless they
are enabled on the Provisioning > OC3 Line tabs. See the
“15.3 Pointer Justification Count
Performance Monitoring” section on page 15-3 .
MS-PPJC-Pdet Multiplex Section Positive Pointer Justification Count, Path Detected
(MS-PPJC-Pdet) is a count of the positive pointer justifications detected
on a particular path on an incoming SDH signal.
MS-NPJC-Pdet Multiplex Section Negative Pointer Justification Count, Path Detected
(MS-NPJC-Pdet) is a count of the negative pointer justifications detected
on a particular path on an incoming SDH signal.
MS-PPJC-Pgen Multiplex Section Positive Pointer Justification Count, Path Generated
(MS-PPJC-Pgen) is a count of the positive pointer justifications generated
for a particular path.