Interlogix Concord 4 User Manual - Manual (Page 28)

26 Concord 4 User Manual
2. For Concord 4 systems, press 030 nnn 2, where nnn is the user number (000
to 229). For Concord Express V4 systems, press 030 nn 2, where nn is the
user number (00 to 15).
3. To turn remote access on, press 2, #. To turn remote access off, press 1, #.
4. Press *, 00, # to exit the programming menus.
System test attribute
This attribute allows the user to perform sensor tests. If the user code does not
have this attribute turned on, the code restricts the user from performing phone
or sensor test. To assign sensor testing to a user:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. For Concord 4 systems, press 030 nnn 3, where nnn is the user number (000
to 229). For Concord Express V4 systems, press 030 nn 3, where nn is the
user number (00 to 15).
3. To turn system testing on, press 2, #. To turn remote access off, press 1, #.
4. Press *, 00, # to exit the programming menus.
Latchkey report attribute
This attribute causes the panel to send a message to a pager when the user
changes system-arming levels (see “Latchkey paging” on page 38.) To assign
latchkey report to user:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. For Concord 4 systems, press 030 nnn 4, where nnn is the user number (000
to 229). For Concord Express V4 systems, press 030 nn 4, where nn is the
user number (00 to 15).
3. To turn remote access on, press 2, #. To turn remote access off, press 1, #.
4. Press *, 00, # to exit the programming menus.
Partition access (Concord 4 systems only)
This attribute determines which partitions a regular user code can control. Only
the system master code can be used to set this attribute. To assign partition
access to a user:
1. Enter the programming menus by pressing 9, system master code.
2. Press 030 nnn 6, where nnn is the user number (000 to 229).
3. Enter the desired partition numbers (1 to 6) you want this user code to
control. The numbers appear as you press the corresponding button. Remove