Interlogix Concord 4 User Manual - Manual (Page 20)

18 Concord 4 User Manual
To confirm whether or not a sensor was bypassed, press * (Status) on the
touchpad. The touchpad displays a list of bypassed sensors or zones.
To bypass sensors indirectly:
1. Leave open only those doors and windows that are to remain open and close
all others.
2. Arm your system to the desired level (the sensor must be active before it can
be bypassed).
The touchpad emits protect beeps and displays PROTEST, because of the
open sensors.
3. At any touchpad press # (Bypass). The touchpad displays BYPASSED ZONES
0 or SENSOR 01 BYPASSED.
The system sounds arming level beeps to indicate that the system is armed
and open sensors have been successfully bypassed.
To arm (unbypass) bypassed sensors, close bypassed doors and windows and
arm your system again.
Basic light control
There are two kinds of light control:
• Basic light control. Instant light control at any touchpad.
• Advanced light control. Lights turn on and off automatically according to
specific situations (see “Advanced light control” on page 34).
To turn all lights on or off:
• From any touchpad, press 0, 0.
• From a 4-button keychain touchpad, press the Lights button.
Note: For system lights to respond to basic and advanced light commands, the
light switches must be turned on.
To turn a specific light on or off, from any touchpad, press 0, light number. You
cannot turn on a specific light using a keychain touchpad.
Basic output control
Your system may be set up with programmed outputs that control special
hardware installed in your system. These outputs are usually set up to turn on
automatically in response to certain events.