Interlogix MC250-4T Series - Manual (Page 13)

IFS MC250-4T/XXX Series User Manual 9
2. Check that the DIN-Rail connector mount is tightly mounted
on the track.
3. Please refer to following procedures to remove the MC250-
4T from the track.
4. Lightly press down and pull the bottom of DIN-Rail
connector mount to remove it from the track.
Mounting to a Wall
To install the MC250-4T on the wall, please follows the
instructions described below.
1. Loosen the screws to remove the DIN Rail from the Media
Converter.