IC Realtime 600TVL / 650TVL 36X High Speed PTZ Camera with 260ft - Manual (Page 13)

6
2222 Protocol Protocol Protocol Protocol,,,, BBBBaud aud aud aud R R R Rate ate ate ate, , , , AAAAddress ddress ddress ddress setup setup setup setup
Before you operate, you need to set protocol, baud rate and address. Otherwise you can not control
the product!
2.1 2.1 2.1 2.1 Protocol and Protocol and Protocol and Protocol and BBBBaud aud aud aud R R R Rate ate ate ate SSSSetup etup etup etup
Please configure the following settings before begin controlling dome:
Address
Baud rate
Parity
Note: Please reboot the speed dome to get all the setups activated!
Open the lower dome, the interface is shown as below. See Figure 2-1.
SW2 SW1
Figure 2-1
SW1
Figure 2-2