GTCO CR 1212 - Users Guide - Manual (Page 24)

CR 1212 24
Use these commands to set the tablet to one of the predefined resolutions listed about.
(Resolution is restricted in Bit Pad One and Two configurations. Refer to Section B: Setting
the Resolution.
Resolution, Definable (Set X, Y Scale)
Command Sequence:
The purpose of the Definable Resolution function is to let you match the tablet resolution
to the resolution of another two-dimensional device, e.g. a computer screen. With
Definable Resolution:
 Define the resolution of each tablet axis, independent of one another.
 Specify the resolution to be any value from 10 lpi to 508 lpi. (Resolution is restricted
in Bit Pad One and Two configurations. Refer to Section B: Setting the Resolution.
After issuing the Definable Resolution command, wait at least 0.5 milliseconds before
issuing another command to the tablet.
If Tablet is operating as a Bit Pad One or Bit Pad Two
Here is how to use Definable Resolution:
1. Determine the resolution that’s desired for the entire length of the (tablet) axis:
 If the other device’s resolution is expressed in “units per…”, such as 37 lines
per inch, multiply that number by the tablet axis length. Example: other
device’s resolution x length of tablet axis = desired axis resolution