GTCO Summagrid IV - Users Guide Part 2 User Manual
Page 12
Summagrid IV 12
1.13.3 Command Syntax
Activate the annunciator for
approximately one quarter of a second;
emits last tone chosen.
Selects one of four different tones for
the annunciator and sounds that tone.
n=1 low tone
n=2 medium tone
n=3 high tone
n=4 highest tone
NOTE: If you want to hear a tone every time a switch is selected, be certain that DIP switch
C5 is in the ON position and use the following command:
Enable Audible Feedback
Disable Audible Feedback
1.14 Relocate Origin Command
1.14.1 Description
This command allows the user to relocate the tablet origin (0,0). The default origin
location is the lower left-hand corner of the tablet active area. The user may move
the origin to either one of four pre-defined locations or to a user-defined position
anywhere within the tablet active area. The pre-defined locations are listed as
follows:
Center of Tablet
Lower Right Corner
Lower Left Corner
Upper Left Corner
Upper Right Corner