GTCO 2500 Series - Users Guide 1/3 - Manual (Page 12)

2500 Series 12
Setting the Soft Switches
During installation, the numbered display blocks act as switches that must be set to select
operating parameters for the tablet. There are eight banks of eight switches. The first five
banks must be set to operate with your software. Activate each bank in turn, setting the
switches as indicated in the tables on the following pages. The number 1 indicates that the
switch light must be on and the number 0 specifies that the light must be off.
1. Select the BANK block. (SELECT a block or switch by placing the crosshairs of the
cursor over it and pressing a button or by setting the stylus tip on the block and
depressing the tip.) The indicator will light, signaling that the switch banks are
accessible. One of the eight numbered blocks will be lit, indicating which bank is
currently active.
2. Choose the display block whose number corresponds to the number of the bank
you wish to set.
3. Select the SETUP block (the BANK indicator will go off and the SETUP indicator will
activate). The lights in the eight numbered blocks now indicate the status of the
switches in that bank. ON or 1 is indicated by a light. OFF or 0 is expressed with no
light.
4. To change a switch setting, choose its block. Switches change from ON to OFF or
OFF to ON each time they are selected.