Great Planes Escapade ARF - GPMA1105 - Manual (Page 28)

small slits in the fuselage for the pointed tabs on the
windscreen, then glue it into position.
❏
7. Use double-sided foam mounting tape (GPMQ4440) to
mount the speed control and receiver to the crutch inside
the fuselage. Be certain to mount them in a location that will
not interfere with the motor, servos or pushrods.
❏
8. Route the receiver antenna out of the bottom of the
fuselage. Tape the antenna to the bottom of the aft end of
the fuselage. Never cut the antenna or coil it up. It is
tuned to a specific length. Be certain the antenna will not
interfere with the pushrods or come into contact with the
propeller.
IMPORTANT:
Whenever connecting the battery always
hold onto the fuselage in case the motor accidentally
receives power and the propeller turns.
❏
1. Turn on the transmitter and connect the battery to the
speed control in the model. Be certain the rudder, elevator
and motor respond as shown in the chart. If required, use
the reversing function in the transmitter to reverse any
controls necessary so they respond correctly.
❏
2. Use the ATV function in the transmitter or adjust the
position of the pushrods on the servo arms or the control
Note: Unless you are specifically checking the operation of
the motor, for safety remove the propeller from the model
while setting it up on your workbench.
Set the Control Throws
PREPARE THE MODEL FOR FLYING
28