Great Planes Escapade ARF - GPMA1105 - Manual (Page 16)

❏
3. Remove the landing gear former. Cut a slot, centered
in the groove, from one mark to the other. Keep the piece of
foam that was removed from the slot you cut, so it can be
glued back into position after the former and the landing
gear have been installed.
❏
4. Use medium CA to glue both 1/32" plywood doublers
(10) to both sides of F1.
❏
5. Test fit the 1/8" plywood front former (3) into the front
of the fuselage. Trim the former as necessary, so it is even
with the front of the fuse. Note the position of the slot.
16