Great Planes Escapade ARF - GPMA1105 - Manual (Page 12)

❏
2. Sand a bevel to the bottom of the leading edge of the
elevator. The elevator is upside-down when the slot for the
control horn is on the left side.
❏
3. Lay the stab and elevator on your workbench with the
slot in the elevator on the right side. Be certain there is a
1/16" gap between the elevator and the stab. Use one piece
of cellophane tape on the top to join the elevator to the stab.
❏
4. Sand a bevel to one side of the rudder (it doesn't
matter which side), then use cellophane tape to join the
rudder to the fin just the same as you joined the elevator to
the stab.
❏
5. Use a hobby knife to carefully widen the slot in the
rudder and the elevator for the 1/32" plywood control horns
(11).
Only a small sliver of foam is to be removed.
12