Grant Instruments SBB Aqua Plus - Manual (Page 6)

29825 Ver. 2 - July 2010 71W SUB, JB & SBB Aqua Plus
Page 5 Operating Manual
www.grant.co.uk
4.0 Operating instructions
4.1
Unpacking instructions
Standard equipment includes:
 Thermostatic bath
 Mains cord with plug
 Gabled polycarbonate lid (all baths except SUB Aqua 34 Plus)
 Polycarbonate base tray(s) (SBB Aqua Plus baths have a metal base tray)
 Operating manual
 Quick start guide (JB Aqua Plus and SUB Aqua Plus baths only)
Remove packing materials carefully, and retain them for future shipment or storage of the
equipment.
4.2
Assembly of the equipment and components
The water bath has three main components, the bath, the lid and the base tray. The base
tray fits into the bath with the feet downward so that it creates a gap between the bottom
of the tank and the tray. The lid should only be lifted by the handle provided as other
parts can become hot during use. It also has a vent/thermometer hole - this hole should
not be sealed as pressure could build up inside the bath.
4.3
Installation
Place the water bath on a level, non-combustible surface. Ensure that the mains plug
and the switch are easily accessible.
4.4
Electrical supply
Check that the supply voltage marked on the serial number label, and the type of mains
plug, are correct for your mains supply outlet, which must have a ground connector.
To disconnect the equipment from the mains supply, remove the mains plug from the
mains supply outlet.