Grant Instruments SBB Aqua Plus - Manual (Page 3)

SUB, JB & SBB Aqua Plus 29825 Ver. 2 - July 2010 71W
Operating Manual Page 2
www.grant.co.uk
EN
Contents
1.0 Use of products 3
2.0 How to use this operating manual 3
3.0 Safety information 3
3.1 Safety compliance 3
3.2 Safety symbols 4
3.3 Safety warnings 4
4.0 Operating instructions 5
4.1 Unpacking instructions 5
4.2 Assembly of the equipment and components 5
4.3 Installation 5
4.4 Electrical supply 5
5.0 Operating procedures 6
5.1 Operation 6
5.1.1 Water level 6
5.1.2 Operation above 60°C 6
5.1.3 Flat bottomed vessels 6
5.1.4 Emptying the baths 6
5.2 Using the JB Aqua Plus 7
5.2.1 Bath controls 7
5.2.2 Indicator lamps 7
5.2.3 Setting the control temperature) 7
5.2.4 Setting the sample protection thermostat 8
5.2.5 Calibration of the temperature control knob 8
5.3 Using the SUB Aqua Plus 9
5.3.1 Bath controls 9
5.3.2 Setting the control temperature 9
5.3.3 Setting the sample protection thermostat 10
5.3.4 Configuring a bath preset 10
5.3.5 Running a bath preset 10
5.3.6 Setting a countdown period 11
5.3.7 Cancelling the timer 11
5.3.8 Locking & unlocking the control panel 11
5.3.9 Single point calibration 11
5.3.10 Twin point calibration 12
5.4 Using the SBB Aqua Plus 13
5.4.1 Bath controls 13
5.4.2 Indicator lamps 13
5.4.3 Setting a controlled boil 13
5.4.4 Setting the constant level device 13
5.4.5 Resetting the over temperature cut-out devices 14
6.0 Technical specifications 14
7.0 Technical Tips 15
7.1 Which water should you use in your bath? 15
7.2 How to prevent rust in water baths 15
7.3 How to prevent algae and bacteria? 16
8.0 Warranty information 16
9.0 Maintenance and service 17
9.1 Cleaning 17
9.2 Fuses 17
9.2.1 Replacing fuses on JB Aqua Plus & SUB Aqua Plus(except SUB Aqua 34
Plus) 17
9.2.2 Replacing fuses on SBB Aqua Plus & SUB Aqua 34 Plus 18
9.2.3 Routine safety tests 18
9.3 Service 18
10.0 Optional accessories 18
11.0 Troubleshooting 18
12.0 Contact Grant Instruments 19
13.0 Compliance 19