Golden Lighting 6390-M1L WG - Manual

INSTALLATION INSTRUCTIONS
Fixture Name: CORONADA 6390-M1L WG
For Pendant Light Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
HANGING THE FIXTURE（Fig.1）
1. Carefully remove the new fixture from the carton and the yellow
bag that holds all parts. Check that all parts are included as shown
in the illustration and parts list.
2. Shut off the power at the circuit breaker and completely remove the old fixture
from the ceiling, including the old mounting strap.
3. Thread Nipple (C) into Canopy Loop (F) until snug, then thread into
Mounting Strap (D).
4. Place Lock Washer (B) and Hex Nut (A) over the end of Nipple (C) and
thread onto the nipple until tight.
5. Take this mounting strap assembly and mount to ceiling junction
box using Junction Box Screws (E). Tighten the screws securely with a screw
driver.
6. Unscrew Canopy Loop Collar (H) from the canopy loop. Pass
the canopy over the canopy loop leaving some threads exposed.
Adjust Nipple(C) until the desired height is reached. *the Canopy loop
collar should fit snugly. Remove the canopy and canopy lock collar.
7. Assemble the fixture and by measuring, determine the correct number
of links needed for proper hanging height. Use a pair of pliers to
open one link of chain to remove and discard the excess.
8. Use one Chain Connector (I) to attach one end of the chain to
Top Loop (J) and close the chain connector.
9. Feed the fixture wires through the chain (every three links) and pull
the wires until taut.
* Make sure the weight of the fixture will be supported by the
chain-not by the electrical wire.
10. Slip Canopy Loop Collar (H) over the chain, then do the same with
Canopy (G). Attach the chain to the Canopy Loop (F) with
Chain Connector (I).
11. Thread the fixture wires and ground wire of the assembled fixture
through the canopy loop (F) and nipple(C) into the outlet box.
Fig.1
JUNCTION BOX
(CEILING)
A
B
D
C
E
F
I
G
H
CHAIN
I
J
CONNECTING THE WIRES (Fig.2)
12. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to WHITE (or
RIBBED).
13. Attach the ground wire (GREEN or COPPER) from the junction
box and the fixture ground wire to the green ground screw on the
Mounting Bracket (B) or connect both wires together using the
correct size of
wire
connectors. Fig.
2
NOTE: Twist the wires together in the same direction you
twist the wire connector onto the wires.
14. Tuck these wire connections neatly into the Junction Box.
HOUSE WIRES
BLACK
(Hot)
15. Raise Canopy (G) to the ceiling and secure in place by tightening
the Canopy Loop Collar (H) into the Canopy Loop (F).
16. Install the light bulbs and glass shade as per the fixture assembly
Sheet.
FIXTURE WIRES
SMOOTH
(or Black)
RIBBED
(or White)
BARE COPPER
(or Green)
WHITE
(Neutral)
GREEN
(Ground)
YOUR INSTALLATION IS NOW COMPLETE. TURN POWER ON AT
TO THE JUNCTION BOX & TEST THE FIXTURE.
For Customer Service, contact the place of purchase to arrange for replacement parts.
C S A0 63 90 1D AL G 1