Golden Lighting 1425-2W WG - Manual (Page 2)

For Wall Mount Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Sancerre 1425-2W WG
For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton
and the yellow bag that holds all your parts. Check
that all parts are included as shown in the
illustrations and the Parts and Assembly Sheet.
2. Shut off power at the circuit breaker and remove
the old fixture from wall, including the old mounting
strap.
3. Mounting Strap (F) contains several pairs of
threaded holes. Find the pair of holes that matches
the holes spacing in your fixture Back Plate (H) and
thread the two Mounting Screws (D) half way into
Mounting Strap (F) and secure with Hex Nut (G).
4. Place Mounting Strap (F) over Junction Box (A)
so that Mounting Screws (D) are vertical or
horizontal, as required by fixture type.
CONNECTING THE WIRES (Fig 2)
6. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or
SMOOTH) and WHITE to WHITE (or RIBBED).
7. Attach the GROUND wire (GREEN or
COPPER) from the Junction Box and the fixture
Ground wire to the green Ground Screw (I) on
Mounting Bracket (F) or connect both wires
together using the correct size of wire connectors. -
NOTE:Twist the wires together in the same
direction you twist the wire connector (L) onto the
wires.
8. Tuck these wire connections neatly into the
Junction Box.
FINISHING THE INSTALLATION(Fig.3)
9. After tucking these wire connections neatly into
the Junction Box and placing the fixture Back Plate
(E) over the two Mounting Screws (D), secure Back
Plate (E) against the wall by threading two Deco
Nuts (O) over the two Mounting Screws (D) until
tight as shown on Fig.1.
10. Install the light bulbs as per the fixture Parts
and Assembly Sheet.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND
TEST THE FIXTURE.
Fig. 3
Fig. 1
Fig. 2
5. Attach Mounting Strap (F) to the Junction Box
using the two mounting screws (H) and tighten
securely with screw driver.