Parts & assembly sheet – Golden Lighting 8106-D5 CDB User Manual

Page 2

For Customer Service, contact the place of purchase to arrange for replacement parts.

8. By measuring determine correct number of links

needed for proper hanging height. Use a pair of

pliers to open one link of the Chain (C2) then

remove the excess Chain (C2) and discard it.

9. Use one chain connector(E2) to attach one end of

the chain to the Top loop (D2) and close the chain

connector.

10. Feed the fixture wires through the Chain (every

three links) and pull the wires until taut.

11. Slip Canopy loop collar (B2) over the chain, then

do the same with the canopy (F2).

12. When ready to complete the installation Use the

other chain connector and attach the other end of

the chain to the canopy loop (A2) and close the

chain connector.

13. Make sure the weight of the chandelier is

supported by the chain-not the electrical wire.

* You may now install the fixture.

Fig 3

3. Unscrew two of the Deco screws (L) from the
Frame (K) and save.
4. Two arms are already attached to the Frame.
Gently spread the arms until evenly spaced.
5. Align the hole in lower side of Frame arm (K) with
hole Frame(K). Secure in place with the Deco
screw (L).
6. Repeat with remaining arms and Deco screws.
* NOTE: The Finial can be scratched or broken if the
full weight of the fixture is placed on it. To avoid
damage attach Finial after hanging the fixture.
7. Attach Finial (N) to the base of fixture Frame (K)
by threading the Finia l(N) onto the threaded rod (M)
until tight.

Fig 2

PARTS & ASSEMBLY SHEET

Fixture Name: Torbellino 8106-D5 CDB

Note: Complete these remaining steps after the

fixture is hung.

14. Place the Glass Shade (P) over the Threaded

Socket (O),place the Socket washer (Q) over the

threaded socket (O) then secure the Glass Shade

(P) by threading by the Socket Ring (R) until tight.

15. Install the light bulbs in accordance with the

fixture's specifications.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)

Fig 4

CHAIN